Sunday, July 14, 2013

Diaper Cake Tutorial



Today we celebrated My Sister-in-law and baby Raelynn! I can't wait to meet that sweet baby girl and so excited that Piper and her will grow up close in age. I had a lot of fun making this diaper cake for the shower. Can't wait to share more pictures of the shower. It was a book themed shower with lots of fun bright colors. We modeled the colors of the shower after Raelynn's Nursery. You can find a tutorial below on how to make the diaper cake.



You will need:

-Size 1 diapers (i used 78 for the 3 tiered cake)
-twine or ribbon
-cake pans or pots in 3 sizes

To Decorate:
-3 Burp bloths
-Baby headband
-Felt balls (about 50)
-Twine
-Wooden letter
-Yarn

Step 1: Create a line of diapers all going the same direction and evenly spaced.

Step 2: Curl the diapers into the first cake pan, adding more if needed so the pan is full.

Step 3: Tie the diapers tight with twine.

Step 4: Carefully remove the diapers from the pan. Slide twine to center of diapers. If using Pampers it will run right along the yellow line on the diapers. Now you will need to slide the diapers to fill in any larger spaces.

Step 5: Once all of the diapers are evenly space you may have a hole in the center. (shown above)

Step 6: Roll up 1-2 diapers and place inside the hole.

Step 7: Your first layer is done! Repeat Steps 1-6 for the next two layers.

Once your layers are done you can stack them, making sure each layer of diapers is going in the same direction.

To Decorate:
Create a topper by rolling three burp cloths and wrapping a headband around all three. I made the burp cloths using cloth diapers and fabric from Fabric Bubb. You can buy felt balls online in all different colors. I ordered mine on Etsy from Handmadeonly and strung them on twine using a larger needle. For the Letter I wrapped grey yarn around a wooden letter that you can find at a craft store. I used a hot glue gun to hold down the yard in certain spots.



1 comment:

  1. Wrapped wheel diaper cakes are way better than rolled ones. Good job on demonstrating that! Thanks for the tutorial!

    ReplyDelete

I'd love to hear from you!